Bimar BL-201DL Mode D'emploi page 13

Water tank (10) Is at the back. It slides out like a drawer and it is locked into place
-
with a lever (9). Add demineralised water that is limescale and additive free (no
essences, detergents or other). Do not exceed the max. level marking (approx. 4L:
running time of approx. 6 hours) or fill to below the min. level (approx. 1 litre). The
2 ice bricks provided can be added to cool the air down further after having been
frozen in a freezer for at least 10 hours.
Front grille: the horizontal flaps (3) can be adjusted up or down manually. The
-
vertical flaps (4), automatically swivel right and left by pressing the button on the
control panel.
Filters. These are found at the back of the appliance, secured with a frame
-
containing two screws (14): the external pre-filter (8) traps dust, fluff, etc., while
the internal filter, made of honeycomb cellulose, is sprayed with water and
thereby cools the air that passes through it.
Control panel with switches for the following functions:
-
"

filled with: this function is most effective in drier air, and is less effective as
relative humidity increases (RH). The button starts and stops the water
pump. The function only takes place in the presence of water in the tank,
within the min-max values; when the water is below the min level switch off
the cooler function.
"0" button stops both the ventilation function and the appliance. It is started

by pressing it.
" " button starts ventilation at minimum speed.

" " button starts ventilation at medium speed.

" " button starts ventilation at maximum speed.

 " " button, see above.
USE
To start the appliance, plug it into the mains and choose the required functions.
To turn the unit off completely, after pressing the "0" button, remove the plug from
the plug point.
If the appliance is not being used for long periods of time, remove the plug from the
plug point and empty the water tank.
" button: cools the air and evaporates micro-particles of H²O it is
13/40