Spraying - Marshalltown ENFORCER E400 Mode D'emploi

Step 1
Ensure the fill/spray toggle switch is
in the FILL/OFF position and that the
mud flow control is turned all the way
in the counterclockwise direction.
Finally, make sure the air flow control
on the gun is turned to the off
position.
Step 4
While holding down the trigger of the
gun, begin adjusting the mud flow.
Simply lift and turn the mud flow control
in a clockwise direction to increase flow
and turn counterclockwise to decrease
flow. Spray on a scrap sheet of mate-
rial and adjust accordingly for desired
texture.
6 of 14
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com

SPRAYING

Step 2
Connect the air compressor hose to
the male air inlet on the pneumatic
assembly. Set the air compressor to
40 psi and adjust as desired. DO NOT
EXCEED 120 PSI. DOING SO COULD
RESULT IN SERIOUS INJURY.
Step 5
Once the desired mud flow is
achieved, lock the mud flow control
by pushing the outer portion of the
dial back down. DO NOT ATTEMPT TO
OVERTIGHTEN THE KNOB. DOING
SO COULD RESULT IN COMPONENT
FAILURE AND SERIOUS INJURY.
Step 3
Once the air compressor hose is
connected, put the backpack on.
There are several adjustments that
can be made to the straps to ensure a
comfortable, snug fit. Once the
backpack is in a secure and
comfortable position, flip the fill/spray
toggle switch to SPRAY and adjust the
gun airflow by opening the ball valve at
the base of the gun.
WS137