Echo REPOWER 90094 Instructions D'installation page 3

13. Slide cutting attachment onto aluminum shaft tube. Be certain
inner drive shaft (H) engages into square socket (I) of cutting
attachment.
14A.(PPF-210/211/251/2100/2110 Only) Align locator hole (B) in cutting
attachment with locator hole in aluminum shaft tube.
14B. (PPSR-2122/2433 Only) Align locator hole (B) in cutting attach-
ment and collar with locator hole in aluminum shaft tube.
15. Install and tighten locator screw (B). Tighten four (4) cutting
attachment screws (A).
NOTE
Cutting Attachment Assembly is complete for models PPF-210, 211,
265. All other models follow steps 16 - 19.
16A.(PPF-2100/2110 Only) Loosen harness clamp screw (J), two (2)
throttle grip clamping screws (K) and engine fan housing clamp
bolt (L).
16B. (PPSR-2122/2433 Only) Loosen four (4) front handle screws (M),
two (2) throttle grip clamping screws (N) and two (2) engine fan
housing clamp bolts (O).
17A. (PPF-2100/2110 Only) Position cutting attachment upright and
rotate harness clamp, throttle grip, and engine upright on drive
shaft and in-line with cutting attachment.
17B. (PPSR-2122/2433 Only) Position cutting attachment upright and
rotate front handle, throttle grip and engine upright on drive shaft
and in-line with cutting attachment.
18. (All Models) Tighten engine and throttle grip fasteners securely.
19A. (PPF-2100/2110 Only) Install harness and position harness clamp
for comfortable operation. Tighten harness clamp screw securely.
19B. (PPSR-2122/2433 Only) Position front handle for comfortable
operation. Tighten four (4) screws securely.
H
I
B
A
J
K
M
3
L
N
O