Textron GREENLEE GT-55e Mode D'emploi page 9

Typical Measurements
Ohm Measurements
(GT-85e only)
Note: The resistance test is only possible when batteries
are installed and in good condition.
Single-pole Voltage Detection Test
>100 V
Grasp
firmly
• This test is not always appropriate for testing whether a
circuit is not live (off). To determine whether the circuit
is not live, use both probes L1 and L2.
• Firmly grasp the insulated grips of the tester to increase
the sensitivity of this test.
Note: Standing on wooden steps, ladders, or insulated
floor coverings can impair single-pole voltage detection.
Unfavorable lighting conditions, such as direct sunlight,
or a non-operational, grounded AC system can also
impair detection.
GT-55e • GT-85e
GT-85e
GT-55e
GT-85e
9