Publicité
SEE LAYOUT DIAGRAM
M1591
V02
1 - INSERT PUSHBUTTON KNOB ON SWITCH S1,S2,S3 AND S4
BEFORE PLACING ONTO PCB.
2 - BREAK THE CONNECTION OF XLR J4 SEE PICTURE.
3 - MOUNT LD1 AND LD2 TOGETHER USING #8607 SPACER.
SEE PICTURE FOR EXAMPLE.
ALSO MOUNT LD3 USING #8607 SPACER AS SHOWN.
4 - USE THE LED BENDING JIG TO BEND THE LEDS
TO THE CORRECT LENGTH.
5 - DO NOT FORGET TO ADD A 2-PIN HEADER
TO THE THERMISTOR HARNESS ASSEMBLY.
6 - BEND C31 AWAY FROM J4 XLR AND THEN RTV
5
SEE PICTURE.
PRODUCTION NOTES
YS#3425
Remove this
piece.
Break this
YS#8636
connection here.
INSERT
LED PHOTO
MAINS VOLTAGE INPUT OPTIONS (NA<->CE)
230V
INSERT
ICE MODULE
115V
PHOTO HERE.
PLACE JUMPER AT P200 FOR 115V (NA) OPERATION.
PLACE JUMPER AT P201 FOR 230V (CE) OPERATION.
Publicité
