Cleaning Method - Coway APM-1010DH Mode D'emploi

cLEANINg mETHOD

- Always unplug the unit before cleaning it.
- Do not use detergents that contain organic solvents (solvent, thinner, etc), bleach,
Tips chlorine, or abrasives.
- Do not place the unit into water or spray water onto it.
Cleaning Air Inlet and Outlet (every 2 months)
Clean the air inlet and outlet with a soft brush.
- Take care that no dust enters the air purifier when cleaning it.
Cleaning Particle Sensor (every 2 months)
Open the particle sensor cover
1
on the right-hand side of the
product. First, clean the air inlet
and outlet vents and then the
particle sensor using a soft brush
or vacuum cleaner.
Use a slightly damp cotton swab and lightly clean the lens, dust inlet
2
and outlet. Then use a dry cotton swab to remove any remaining
moisture.
- Without regular cleaning, the performance of the particle sensor
will deteriorate.
- The cleaning cycle differs depending on the operating
environment. When using the product in a dusty environment,
you will need to clean the sensor more often.
Cleaning front cover
Separate the front cover from the unit and remove any dust attached
to the surface with a soft cloth or brush. Use a damp cloth if the
contamination is serious. (However, do not use abrasives.)
Cleaning the Unit (every 2~4 weeks)
Use a dry, soft cloth to clean the product body. Use a damp cloth if the
contamination is serious. (However, do not use abrasives.)
Air outlet
Dust outlet
Dust inlet
15
16