Cleaning Method; Product - Coway AP-1512HH Mode D'emploi

CLEAnInG METhOD

- Always unplug the air purifier before cleaning the product.
- Do not use detergents that contain organic solvents (solvent, thinner, etc), bleach,
chlorine, or abrasives.
TIPS
- Do not put the air purifier in water or spray water directly on it.
■ Cleaning the air quality sensor
(every 2 months)
1. Open the air quality sensor cover on the
right-hand side of the product. Clean the
air inlet and outlet vent and then the air
quality sensor with a soft brush or vacuum
cleaner.
2. Wet a cotton swab lightly and clean the lens, dust inlet, and dust
outlet. Clean them with a dry cotton swab to remove remaining
moisture.
∗ Without regular cleaning, the performance of the air quality sensor deteriorates.
∗ The cleaning cycle differs depending on the operation environment. When using the
product in a dusty environment, clean the sensor more often.
■ Cleaning the air inlet and outlet (every 2 months)
Clean the air inlet and outlet with a soft brush.
∗ Exercise caution not to have dust fall inside the air purifier.
∗ If covered in dust, run the air purifier in manual mode for 10 minutes to
blow the dust off the vent. You may then continue with normal use.
■ Cleaning the front cover
Separate the front cover from the product and remove the dust
attached to the surface with a soft dry brush or cloth.
∗ Use lightly wet cloth if the contamination is serious but do not use abrasives.
■ Cleaning the product body (every 2 ~ 4 weeks)
Use dry, soft cloth to clean the product.
∗ Use lightly wet cloth if the contamination is serious but do not use abrasives.
Air
outlet
Air
inlet
Dust outlet
Dust inlet