Servicing Safeguards - FAR MWC25 Manuel D'utilisation

ENGLISH
If "NO" is the answer to any of the above
questions, please check your wall socket and the
fuse in your meter box.
If both the wall socket and the fuse are
functioning properly, CONTACT YOUR
NEAREST SERVICE CENTER
APPROVED.

SERVICING SAFEGUARDS

Caution: MICROWAVE RADIATION
1. The high voltage capacitor remains charge
after disconnection; short the negative
terminal of H. V capacitor to the oven
chassis (use a screwdriver) to discharge before
touching.
2. During servicing below listed parts are liable
to be removed and give access to potentials
above250V to earth.
– Magnetron
– High voltage transformer
– High voltage capacitor
– High voltage diode
– High voltage fuse
3. The following conditions may cause undue
microwave exposure during servicing.
– Improper fitting of magnetron;
GB-40
– Improper matching of door interlock, door
hinge and door;
– Improper fitting of switch support;
– Door, door seal or enclosure has been
damaged.
!
CAUTION
1. If LED displays Err0 during working, it
indicates that sensor has been short circuit
and you need replace it at the nearest
repaired department.
2. If LED displays Err1 during working, it
indicates that sensor has been open circuit
and you need replace it at the nearest
repaired department.
ENGLISH
GB-41