AVIRE AC-DAT18-110-F-0L-000 Manuel D'installation page 5

The below diagrams represent an example 4-Wire & 2-Wire CANbus connection:
7. Connection RS-232
This connector is for the exclusive use of Avire technical personnel.
8. CAN Addressing
IMPORTANT – If CAN addressing is incorrect the system will not work correctly
SW1 Function Description
In a system with more than one elevator car you need to select the
elevator shaft for each DAU. The below table shows how you can set
the ID for each DAU.
Shaft (car)
number
Not used Not used
Activates the CANBus End of Line (EOL) for the CAN connector.
CAN Ω
ON – DAU is always the End of Line device.
5