Configuration Of The Outputs - AVIRE AC-DAT18-110-F-0L-000 Manuel D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Configuration of the outputs

Each of the outputs can be configured independently by selecting the value of the
corresponding parameter.
DAU
Parameters
145
146
Summary of direct commands
Direct commands are those that cause immediate action on the device, therefore they
are not configuration parameters. The following table lists the available direct-action
commands.
Command
01
02
09
10
* -You must enter the security password as a parameter for these commands.
Example: To execute a reset (10) the following command should be sent:
Description
Output 1
Output 2
Value
0
1
2
3
4
5
The security password is: "1234567890"
Parameter Value
0
0
Description
Permanent Standby Output
Permanently activated output
Filter alarm push button
Alarm push button without filter
Error in the last test or DCP disconnected
Damaged or disconnected battery error
Description
End of alarm (EOA)
Clear alarm (CA)
Return to factory
default*
Equipment Rest*
8

Publicité

Table des Matières
loading

Table des Matières