Table Des Matières; Electrical Grounding; Electrical Supply - hestan KRT Manuel D'utilisation Et D'entretien

TABLE OF CONTENTS
3 SAFETY PRECAUTIONS - BEFORE YOU BEGIN
8 MODEL NUMBERS
9 RATING LABEL
9 REGULATORY / CODE REQUIREMENTS
10 GETTING STARTED WITH YOUR APPLIANCE
14 USING THE RANGETOP
16 USING THE GRIDDLE
17 SMART BURNER TM
19 SMART BURNER TM
23 SMART BURNER
TM
24 SMART BURNER TM
26 CARE & MAINTENANCE
27 TROUBLESHOOTING GUIDE
29 COMPLIANCE INFORMATION
30 PARTS LIST / SERVICE
30 LIMITED WARRANTY
SAFETY PRECAUTIONS - BEFORE YOU BEGIN
When properly cared for, your Hestan appliance will provide safe, reliable service for many years.
When using this appliance, basic safety practices must be followed as outlined below.
INSTALLER: Please leave these Installation Instructions with the owner.
OWNER: Please retain these Installation Instructions for future reference.
This rangetop is designed for residential use only It is NOT designed for installation in manufactured
(mobile) homes or recreational park trailers. Do NOT install this rangetop outdoors.
ELECTRICAL SHOCK HAZARD ELECTRICAL SHOCK HAZARD
Disconnect power before installing or servicing appliance. Before turning
power ON, be sure all controls are in the OFF position. Failure to do so can
result in electrical shock or death.

ELECTRICAL GROUNDING

ELECTRICAL GROUNDING
This appliance must be grounded. Grounding reduces the risk of electric shock
in the event of a short circuit. Read the ELECTRICAL CONNECTIONS section of the Installation
Manual for complete instructions.
This appliance is equipped with a 3-prong grounding plug for your protection against shock hazard
and should be directly plugged into a properly grounded receptacle. Do not cut or remove the
grounding prong from this plug.

ELECTRICAL SUPPLY

ELECTRICAL SUPPLY
This appliance must be on its own dedicated circuit, 120 VAC, Single Phase, 60 Hz, with a current
rating of 15 Amps. Have the installer show you where the electric circuit breaker is located so
you know how to shut off the power to this appliance. It is the responsibility of the user to have
the appliance connected by a licensed electrician in accordance with all local codes, or in the
absence of local codes, in accordance with the National Electrical Code. Read the ELECTRICAL
CONNECTIONS section of the Installation Manual for complete details.
(SOME MODELS)
- SETUP
- MANUAL MODE
- THERMOSTATIC MODE
©2021 Hestan Commercial Corporation
EN
3