Acqua Brevetti BRAVOFIL FT020 Manuel D'usage Et Entretien page 20

B1.6 Allowed installation schemes
The assembly should be performed respecting one of the schemes indicated here below:
Follow
direction indicated by the
row stamped on the brass
head of the filter.
Warning! It is necessary to install the filter following the water flow direction indicated by the row
stamped on the brass head of the filter.
BravoFIL filter owns a 360° brass connection plate that can turn at intervals of 90°.
In order to change the orientation of the brass connection plate it is enough to untight the allen nuts (using a
6 mm allen wrench). Orientate the plate connection in the desired direction, taking care to position the white
shaped gasket sited between the brass plate and the acetal resin white head in a correct manner.
Installation 1.
Left entrance
Right exit
Any other arrangement may cause the non proper operation of the device.
The filter discharge connection must be canalized in a drain.
In case of doubt contact with Acqua Brevetti s.r.l. (Tel.: +39.(0)49.8973432 or send an e-mail to
info@acquabrevetti.it).
MAN126
BRAVOFIL - ENGLISH
the water flow 6 mm allen nuts to tight the
brass connection plate.
Installation 2.
Bottom entrance
Top exit
Installation 3.
Right entrance
Left exit
Installation 4.
Top entrance
Bottom exit
PAG.E-9