Power The Projector; System Requirements; Install The Driver - AIPTEK T25 Manuel D'utilisation

T25's User's Manual

Power the projector

PocketCinema T25 can get the power in two different ways
1. Power adapter: If power adapter is connected the brightness can reach 25 peak
lumens. In power mode it's not necessary to connect the second (yellow) USB
cable with your PC/Notebook.
2. USB Mode: In USB mode, both USB cables (black for data and yellow for power)
need to be connected with T25. The brightness can reach 18 peak lumens in
USB mode.

System Requirements

Your system should have at least the following specifications to make PocketCinema
T25 working smoothly on your system:
Operating System:
CPU:
RAM:
Interface:
Hard Disk:

Install the Driver

Before using the projector to projection, you need to install the Pico Projector driver
on your Notebook/PC.
1. Use USB cable to connect the device to your Notebook/PC. The T25 is detected
as mass storage device and a pop-up window appear. Click the icon to open the
folder and than "Pico Projector.exe" to start the driver installation.
2. The Setup Wizard will appear to select the language you prefer. Simply follow the
on-screen instructions to continue the installation.
3. During the driver installation, Hardware Installation dialog may pops up. Please
click Continue Anyway on the Hardware Installation dialog window.
For Windows XP
www.aiptek.eu
Windows XP SP2 or higher, Windows Vista, Windows 7
Dual Core CPU or higher
2GB DDR RAM or higher
2x free USB 2.0 Ports (1x free USB port if AC adapter is
used)
50MB free space
Page 6
For Windows Vista /7