Volume Knob/Tone Controls; Setup Options - Rockford Fosgate RFX Serie Manuel D'installation Et Fonctionnement

VOLUME KNOB/TONE CONTROLS

The Volume knob is a multifunction controller and handles
the Volume, Tone Controls, and Setup Options, see below.
To Control Volume
1. Turn the VOLUME knob (Volume Outside) clockwise to
raise volume.
2. Turn the VOLUME knob (Volume Outside) counter-
clockwise to lower volume.
To Adjust Tone Controls
1. Press the SELECT button (Volume Center) repeatedly to
cycle through BASS > TREBLE > BALANCE > FADER >
SUM > VOLUME.
2. Turn the VOLUME knob (Volume Outside) to increase,
clockwise, or decrease, counter-clockwise, the selected
function.
Source Tone Memory
Individual Bass & Treble settings are memorized for TUNER / CD PLAYER / CD CHANGER / AUX1.
NOTE: If no adjustment is made after 5 seconds, the MENU knob will revert to VOLUME mode.

SETUP OPTIONS

The list below shows the default Setup Options. The bracketed items are
the alternate options contained within each Setup Option.
Selecting Options
1. Press and hold the SELECT button (Volume Center) for about 1
second until the first Option appears {LOCAL}.
2. Press the SELECT button (Volume Center) repeatedly to cycle through
all Setup Options. The first three options only affect the Tuner Mode.
3. To change an Option, press the UP or DN {Down} Button
( or ).
4. To store, wait 5 seconds and the Display will return to the last Mode
shown.
• LOCAL [DX] — Adjusts the sensitivity of the tuner for rural conditions
where there are weak radio stations while Local adjusts the sensitivity for
city conditions where there are several strong radio stations.
• AMERICAS [EUR/AUST] — Allows tuning of frequencies available in
different parts of the world.
• P. PLAY [EJ MUTE] — Plays the Tuner after you eject a CD while Eject
Mute mutes the Tuner after you eject a CD.
• V/BAR ON [V/BAR OFF] — Displays the Volume Bar at the bottom of the Front Panel while
Volume Bar Off turns it off.
• INI VOL 15 — Sets the maximum Initial Volume when the unit turns on. Initial Volume sets
point of maximum volume when the unit is turned on. If the volume setting was lower than the
initial volume setting when the unit is turned off, then the lower volume will be used at turn on.
If the volume setting was higher than the initial volume setting, then the initial volume setting is
used at turn on. This feature prevents accidental high volume turn on as well as allows high
volume settings to be retained in case another preamplifier is the system's main volume control.
• CONTRAST [VIEW 6] — Controls the view angle of the display. Allows adjustment for best
visibility.
O
PERATION
Turn Outside
Press Center
Press & Hold Center
SEL
– B
ASIC
SEL
Remote
SEL
Remote
ENT
11