Delta 50-345 Mode D'emploi page 5

NOTE: Position the flat washers (M) Fig. 15 between the pivot bracket (B) and the foot lever (J) Fig. 16.
ADJUSTING THE LEVELING SCREWS
You can adjust the mobile base (A) Fig. 17 level with the floor surface by raising or lowering the leveling screws (B). To
adjust the height of mobile base (A) Fig. 17, loosen and tighten the four hex nuts (two of which are shown at (C).
NOTE: Make this adjustment with foot lever (D) in the raised position.
RAISING AND LOWERING THE MOBILE BASE
1. To raise the mobile base, push the foot lever (A) downward until it locks into position (Fig. 18).
2. To lower the mobile base, flip the foot lever (B) Fig. 19 upward until the mobile base (A) is resting on the floor
surface.
IMPORTANT: To avoid personal injury, always operate the machine with the foot lever (B) in the raised position. (Fig.
19).
IMPORTANT: When placing your machine or stand on the mobile base, make certain that the foot lever (B) Fig. 19
is in the raised position to avoid movement of the mobile base (A).
For assistance with your machine, visit our website at www.deltamachinery.com for a list of service centers or call the
DELTA Machinery help line at 1-800-223-7278 (In Canada call 1-800-463-3582).
J
M
B
Fig. 16 Fig. 17
A
Fig. 18
TROUBLESHOOTING
5
C C
A
C
B
D
B
Fig. 19