Ego Power+ BC1500E-F Manuel D'utilisation page 11

3. Cut 4m long cutting line, Insert the line into the
mounting hole inside the eyelet. Push and pull the
line from the other side until equal amounts of line
appear on both sides of the spool(Fig. O).
Fig. O parts description see below:
O-1 Eyelet
4. Press, while rotating the lower cover assembly in
the arrow direction, to wind the line onto the spool
until approximately 14cm of line is showing on each
side(Fig. P).
5. Push the lower cover assembly down while pulling on
the lines to manually advance the line and to check
for proper assembly of the trimmer head.
When the cutting line breaks from the line outlet or the
cutting line is not released when the trimmer head is
tapped, follow the steps below:
1. Remove the battery pack.
2. Press the release tabs on the upper cover and
remove the lower cover assembly by pulling it
straight out(Fig. Q).
Fig. Q parts description see below:
Q-1 Release Tab
Q-2 Lower cover assembly
Q-3 Upper cover
3. Remove the cutting line from the spool.
4. With one hand holding the upper cover, use the other
hand to grasp the lower cover assembly and align the
tabs on the upper cover with the holes in the lower
cover assembly; use your palm to press the lower
cover assembly until the tabs lock with the upper
cover(Fig. R).
5. Following the instructions in " LINE REPLACEMENT "
to reload the cutting line.
56 VOLT LITHIUM-ION BRUSHLESS BIKE HANDLE LINE TRIMMER — BC1500E-F
MAINTENANCE
WARNING:
When servicing, use only identical
replacement parts. Inspect and maintain the machine
regularly. To ensure safety and reliability, all repairs
should be performed by a qualified service technician.
WARNING:
Battery tools do not have to be plugged
into an electrical outlet; therefore, they are always in
operating condition. To prevent serious personal injury,
take extra precautions and care when performing
maintenance, service or for changing the cutting
attachment or other attachments.
WARNING:
To prevent serious personal injury,
remove the battery pack from the tool before servicing,
cleaning, changing add-on attachments or removing
material from the unit.
CLEANING THE UNIT
◾
Clean the unit using a damp cloth with a mild detergent.
◾
Do not use any strong detergents on the plastic
housing or the handle. They can be damaged by certain
aromatic oils, such as pine and lemon, and by solvents
such as kerosene. Moisture can also cause a shock
hazard. Wipe off any moisture with a soft dry cloth.
◾
Use a small brush or the air discharge of a small
vacuum cleaner brush to clean the air vents on the
rear housing.
STORING THE UNIT
◾
Remove the battery pack from the line trimmer when
it is not in use.
◾
Clean the tool thoroughly before storing it.
◾
Store the unit in a dry, well-ventilated area, locked-up
or up high, out of the reach of children. Do not store
the unit on or adjacent to fertilizers, petrol, or other
chemicals.
EN
11