Moulinex city space Manuel D'utilisation page 16

903397-01_MO24_city-space_903397/01 10/07/13 09:32 Page10
Changing the microfilter* (ref. MT0005.01)
Important: Change the microfilter* every 6 months.
The microfilter* is available at your local retail store or at one of our Authorized Service Centres.
• Open the lid (8) of your vacuum cleaner -
• Remove the motor protection grid* (12) –
• Remove the microfilter* (13) –
• Throw the microfilter* (13) in the rubbish bin -
• Place the new microfilter (13) on the motor protection grid* (12) –
• Slide the ledges into the slots –
• Screw on the motor protection grid* (12) –
• Make sure that the motor protection grid* is correctly positioned (12) before closing the lid (8).
The air we breathe contains particles that can be allergenic: larva and dust mite faeces, mould, pollen, smoke and
animal waste (hair, skin, saliva, urine). The finest particles can penetrate deep inside the respiratory system or
cause inflammation, affecting the entire respiratory function.
(H)EPA ([High] Efficiency Air Particle Filter) filters, retain even the smallest particles. Thanks to the (H)EPA filter,
the air released into the room is cleaner than the air vacuumed.
Changing the hepa* filter cassette (ref : MT0007.01) suitable to paper bags
Important: Replace the HEPA filter cassette* MT0007.01 every 6 months (according to use frequency).
The (H)EPA filter cassette* ref. MT0007.01* is available at your local retail store or at one of our Authorized Service
Centres.
• Open the lid (8) of your vacuum cleaner -
• Remove the HEPA filter cassette* (14a) –
• Throw the cassette in the rubbish bin -
• Slide the ledges of the new HEPA filter cassette* into the slots –
• Screw on the new HEPA filter cassette* (14a) (ref. MT0007.01) in its compartment –
• Make sure that the HEPA filter cassette* (14a) is correctly positioned before closing the lid (8).
Cleaning the hepa filter cassette* (ref : RS-RT900034), suitable for textile
bags*
Attention! This cleaning procedure is exclusively reserved to the HEPA filter cassette* ref: RS-RT900034.
Important: Clean the HEPA filter cassette RS-RT900034 every 6 months (according to frequency of use).
The (H)EPA filter cassette* ref. RS-RT900034* is available at your local retail store or at one of our Authorized
Service Centres.
• Open the lid (8) of your vacuum cleaner -
• Remove the HEPA filter cassette* (14b) –
• Tap the HEPA filter cassette* (14b) over a dustbin -
• Rinse under running water –
• Make sure that the HEPA filter cassette* (14b) is perfectly dry before reinserting it.
• Slide the ledges into the slots -
• Screw on the HEPA filter cassette* (14b) (Ref: RS-RT900034) in its compartment –
• Make sure that the HEPA filter cassette* (14b) is well placed before closing the lid (8).
Cleaning the vacuum cleaner
• Wipe the body of the vacuum cleaner and accessories with a soft damp cloth, then dry.
• Wipe the lid with a dry cloth -
• Do not use detergents or any corrosive or abrasive products.
6. TROUBLESHOOTING
Important: If you notice that your vacuum cleaner is not operating as well, before carrying out any checks,
switch it off using the ON/OFF pedal.
10
*Depending on model: it means special equipment for some models or optional accessories.
fig.14
- and remove the bag.
fig. 17a
.
fig. 17b
– and keep the motor protection grid* (12).
fig.17c
.
fig. 17d
.
fig. 17e
.
fig. 14
- and remove the bag –
fig. 18a -18b
fig. 18c
.
fig. 14 , then remove the bag –
fig. 19a-19b .
fig. 19c
fig. 19d
and let dry for at least 24 hours –
fig. 19f
.
fig. 20 .
fig. 17d
.
fig. 15a
.
.
fig. 18d .
fig. 16a .
.
fig. 19e
.
fig. 19g
fig. 18e .
.