even if this car is a ready to run kit, you still have some little things to do to familiari ze with your
product.
please follow these steps.
kT2S TRANSMITTeR fUNCTIONS
Steering Wheel : Control direction (Left / Right) of the
Throttle Trigger : Control speed and direction (Forward/
Antenna : Transmit signal to the model
Power ON / OFF : Power ON / OFF the transmitter
SYNC & Battery Indicator : Top
Power Indicator : LED light indicates power "ON".
ST. Trim Dial : Adjust the neutral position of steering
TH. Trim Dial : Make sure the model stays still when
Battery Compartment Tray : Cover and hold the batteries powering
bATTeRy INSTALLATION
Supplied with 4 x 1.5V AA Batteries,
KT2S can be operated a few hours.
Installation: ❶ Remove the battery
compartment cover as shown
below.
ReCeIveR ANd SeRvO CONNeCTION
ESC
Receiver
6
RC model
Brake/Backward) of the driving model.
Green
LED
light
synchronization
status
adequate battery power supply.
ATV : Adjustable Steering Rate by ATV dial
servo when model wheels are straight
ahead.
releasing the throttle trigger.
the transmitter.
❷ Install the batteries
observing the polarity
marked on battery
compartment.
Connect to motor
Connect to
battery
Power Switch
CH2
Steering Servo
CH1
ATV
Power
Indicator
Power
ON / OFF
Steering
Reverse Switch
Throttle
indicates
Reverse Switch
and/or
Steering
Trim Dial
Throttle
Trim Dial
Battery
Compartment Tray
❸ Then reinstall the battery
compartment cover as the
Picture shown below.
pRe-RUN CheCk
LED
indicateur
LED
indicator
* Always turn on the transmitter first by sliding the switch on
the left side from bottom to top. The green lights above the
switch should light up. If not, you need to check for low or
incorrectly installed batteries.
Antenna
Steering
Throttle
Trigger
Setup Key
CAUTION :
Do not dispose of batteries in fire,
short their terminals, apply heat to
them or disassemble them. .
Used batteries: Please dispose of
used batteries properly, following
any local regulations.
Battery distributors are required by
law to take back spent batteries;
they must not be thrown away as
household waste.
1. Steering : Adjust the steering
trim to keep the front wheels
in straight line when steering
wheel remains in NEUTRAL
position.
2. Throttle : Adjust the throttle
trim to ensure the wheels stop
rotating when throttle trigger
remains in NEUTRAL position.
Wheel
Bind /