Troubleshooting Guide - Aqua Laser BRILLIANT STOOMREINIGER Manuel D'instructions

6. If you want to remove the adapter from the base unit, press on the adapter's unlatching lever and
remove it from the base unit.
7. Move the on/off switch on the back of the appliance.
8. When the appliance has reached its operating temperature, steam is emitted by pressing the handle
of the steam activator. You can now start cleaning.
9. Slowly move the attachment backwards and forwards over the surface to be cleaned and press the
steam activator as required. Hold the attachment for approximately 10 seconds over areas which need
to be cleaned especially thoroughly.
10. When the water tank is empty and steam is no longer being produced, switch the appliance off, pull
the plug out of the plug socket and wait until the appliance has cooled down. Then remove the water
tank and refill it with water.
11. If the cleaning process has finished and the appliance has completely cooled down, remove the water
tank, empty it and let it dry.
12. Before using the appliance again, the water tank should always be checked for any residual water and,
if necessary, completely emptied.
Cleaning and storage

Pull the plug out of the plug socket before cleaning.

Only return the appliance to its storage place once it has fully cooled down and there is no water left n
the water tank.

Never immerse the appliance in water and do not rinse it under running water.

Do not use solvents or abrasive cleaning agents.

The safety of the appliance can only be guaranteed when it is regularly checked for damage and wear
and tear.

Do not use any corrosive or abrasive cleaning agents for cleaning. These could damage the surface.

When necessary, wipe the appliance with a damp cloth and possibly some mild cleaning agent.

Remove dirt from the attachments (hairs, fluff etc.)

The floor cleaning cloth can be washed in a washing machine at 60°C. Although the microfiber cloth is
able to endure the hot steam, you have to be careful with the plastic clasp on the cord of the cleaning
cloth. We therefore recommend to wash the microfiber cloth at 60°C. It is NOT suitable for tumble
drying.

Do not put the appliance back in its place until it has completely cooled down and has been emptied of
water.

Keep the appliance in a dry, clean and cool place which is inaccessible to children
Trouble shooting guide
Caution: Prior to troubleshooting isolate the unit by removing the cord from the power socket.
If the appliance does not function properly, please check first of all whether you can solve the problem
yourself. Do not attempt to repair a defective appliance yourself.
Problem
Copper ball does not sink in the water tank
Steam mop will not produce steam
Pale residue left on the floor
Steam mop steams water instead of steam
Steam mop drips
Solution
Wiggle it and make sure the copper ball is still in the
water tank.
Ensure the water tank has correct level of water.
Caused by leaving the steam mop in the same
position for too long.
Can be removed with household white vinegar or a
decalcifying product. Alternatively reheat the area for
one minute and residue should be removed.
CAUTION: do not overheat area.
Let the steam cleaner warm up for 30 seconds before
you put the switch into action.
Ensure:
- if the filter and/or water tank is assembled well