Filling The Water Tank - Aqua Laser BRILLIANT STOOMREINIGER Manuel D'instructions

Essemble the stand for the floor steam cleaner
The stand for the floor steam cleaner is supplied in three parts. The handle, the middle piece (with base unit) and
the cleaning head.
1. Insert the handle onto the middle piece until you hear a click.
2. Insert the steam outlet nozzle at the bottom end of the middle piece into the adapter of the cleaning
head. You must hear it click into place.
3. To put the appliance away, wind the power cable loosely around the top and bottom hooks provided for
holding the cable.
4. If you want to remove the cleaning head, press the unlatching lever where the cleaning head joins the
middle piece and remove it.
USE

Always check the floor cleaning cloth for wear before each use. It must not be used if it is visibly worn or
damaged. This could result in damage to your floor covering.

The steam cleaner should only be used with floor cleaning cloths specifically manufactured for it.

When cleaning, ensure that the floor cleaning cloth is firmly attached to the cleaning head in order to
avoid damage to the appliance or floor covering.

Never direct the steam at people, animals or equipment which contains electrical components (e.g.
oven interiors, refrigerators, switches and lights, microwaves etc.).

Beware – risk of scalding! Never touch the appliance's cleaning head/attachment while in use.

The floor cleaning cloth can remain very hot for a short time after use. If you want to remove it, wait
until it has cooled down and the appliance is no longer emitting any steam.

Put the appliance back in its place only when it has completely cooled down.
BEFORE USE - IMPORTANT
Water residue in the filter and in the tank can be attributed to the appliance having been tested. When using the
appliance for the first time, or if the appliance has not been used for a long time, it may take some time after
switching on for steam to be generated, as the appliance's pipes are not yet filled with water. Steam can only be
emitted when the appliance has reached its operating temperature and the appropriate parts of the appliance
have filled with water. To do this, press the steam activator.
Before using the steam mop, test on an inconspicuous area of the carpet or rug for color fastness!

FILLING THE WATER TANK

1. Turn the water tank catch anticlockwise slightly and remove it from the tank.
2. Fill the tank with water.
3. Then lock the water tank by replacing the water tank catch and turning it clockwise.
Because of the copper ball in the water tank, the appliance is suitable for horizontal use, for the cleaning of
wall tiles.
Use as a floor steam cleaner
It is recommended that the floor is swept with a brush or vacuum cleaned before using the appliance. Always
test the cleaning performance first in a small inconspicuous area.
1. If the base unit is already in the stand for floor cleaning , miss out the following steps 1 to 3. If the
adapter is fitted to the base unit, press on the adapter's unlatching lever and remove it from the base
unit.
2. Insert the base unit's steam outlet nozzle into the adapter in the bottom part of the stand for floor
cleaning.
3. Press the handle of the base unit into the stand until you hear the locking mechanism click into place.
4. Pull the floor cleaning cloth over the cleaning head and tighten the rubber spring. When you want to
remove the floor cleaning cloth, press the catch on the rubber spring to release the cloth.
5. Insert the plug into a properly installed and easily accessible plug socket.
6. Move the on/off switch to position I. The indicator lamp on the front of the appliance lights up and the
appliance heats up. Rotate the steam regulator to adjust the size of steam you want.
7. Release the standing position by placing your foot on the cleaning head and tilting the stand.