8. When the appliance has reached its operating temperature, steam is emitted when the steam
activator is pressed. You can now start cleaning the floor.
9. Slowly move the cleaning head backwards and forwards over the surface to be cleaned (do not press
to hard!) and press the steam activator as required.
10. For cleaning carpets, insert the cleaning head (with the floor cleaning cloth) into the carpet glider.
11. When you want to replace or rinse out the floor cleaning cloth, switch the appliance off with the
on/off switch and remove the plug from the plug socket. Never pull on the cable always pull at the
plug. Wait a few minutes so that the appliance and floor cleaning cloth can cool down.
Be aware that when turning off the appliance a wet area can form beneath the cleaning head.
Afterwards you can replace the floor cleaning cloth.
12. Once the water tank is empty and steam is no longer being generated, switch the appliance off, pull the
plug out of the plug socket and wait until the appliance has cooled down. Then refill it with water.
13. If the cleaning process has finished and the appliance has completely cooled down, remove the water,
empty it and let it dry.
14. Turn op the top hook for holding the cable upwards and roll up the cable.
15. Remove the floor cleaning cloth from the cleaning head and rinse it out.
16. Store the appliance upright in a cool, dry place. To stop the appliance, return it to a vertical (standing)
position. Engage the pivot on the cleaning head and the appliance is locked in place.
17. Before using the appliance again, the water tank should always be checked for any residual water and, if
necessary, completely emptied.
ATTENTION: On surfaces that have been treated with wax, the wax may be removed by the heat and steam
action. Do not use on unsealed wood floors or let unit stand on any wood floor for an extended period of time.
This could cause the wood grain to rise. When using on vinyl, linoleum or any other heat sensitive floors, use
extra caution. Too much heat can melt down glue in the flooring. It is therefore recommended that a sample
cleansing be carried out on an isolated area of the floor. It is also recommended that you check the use and
care instructions of the surface from the floor manufacturer to ensure suitability to steam cleaning.
Accessories
1. Carpet glider. Only for carpets. Not suitable for: laminate, tiles & smooth floors.
2. Window cleaner. Ideal for window cleaning.
3. Nozzle with cleaning cloth for glass cleaning and hard surfaces.
4. Long brush attachment. To remove dirt, in grooves and crevices, for instance.
5. Spatula attachment. To remove stubborn stains, such as lime scale and deposits.
6. Circular brush attachment. To remove stains, for instance on tiles, wheel rims, mirrors and non-cold
glass surfaces.
7. Nozzle attachment. To clean places that are not readily accessible or crevices, for instance.
8. Jet nozzle
How to use
1. If the base unit is located in the stand on the
floor cleaner, push the unlatching button in
order to release the locking mechanism.
Remove the mop head from the stand.
2. Insert the jet nozzle onto the appliance's steam
outlet nozzle. You must hear it click into place.
3. Select an attachment (see above) and insert it
onto the jet nozzle until it stops. When
attached, the flexed end piece of the appliance
(with the exception of the spatula attachment)
must point to the left when the base unit is
held with the water tank facing you.
4. Turn the attachment 90 degrees.
5. To remove an attachment from the adapter,
turn it back 90 degrees and then pull it off.