End Stop Bar - Super Ego 189 Mode D'emploi

7. OPERATING CONTROLS AND ADJUSTMENTS

7.12 END STOP BAR

The end stop bar (A) allows for the cut length to be set,
repeating cuts with the same length. To move the end
stop bar, loosen the screw with the hexagonal head (B)
(fig 27) with the corresponding allen key that is located on
the back of the base of the band saw (Fig. 26).
A
B
Elements of Fig. 27
A: End Stop Bar
B: End Stop Bar fastening screw
Fig. 27
To install the end stop bar on the band saw, thread the
bar (B) onto the bench lathe and then tighten the screw
(A) (Fig. 28)
Elements of Fig. 28
A: Screw
B: End Stop Bar
A
B
Fig. 28
44