Operating Controls And Adjustments; Power On Switch; Actuators - Super Ego 189 Mode D'emploi

7. OPERATING CONTROLS AND ADJUSTMENTS

BAND SAW WITH VERY SHARP BLADE AND
POWERED UP.
If when the band saw is plugged in to the mains the
(A) switch - (Fig. 7) it is not in the "OFF" position, the
cutting blade may cause serious cutting injuries to the
user.
If the tension power rating shown on the technical
specifications plate of the band saw does not match
the tension of the mains power supply, the band saw
may be damaged due to a power overload.
Make sure that the mains supply voltage is the same
as that shown on the machine's specification plate
and that the switch is set to the "OFF" position
before plugging the band saw in to the mains.

7.1 POWER ON SWITCH

Press the (A) switch until the "ON" position is lit - (Fig. 7).
WARNING
A
Fig. 7
The start up actuators are located on the upper handle
and the lower handle (Fig. 8).
B
Elements of Fig. 7 - 8
A: Main switch
B: Upper handle
C: Lower handle

7.2 ACTUATORS

The start up actuators are located on the upper handle
(Fig. 9) and on the lower handle (Fig. 10).
A
C
Fig. 8
B
Fig. 9
38