Extel O'MOUV Guide D'installation Et D'utilisation page 79

Screen icons:
1. Vertical sweep
2. Horizontal sweep
3. Menu
4. Reverse
5. Mirror
6. Stop the video and return to the home page
7. Take a photo
8. Record a video
9. Activate the microphone (Not used)
10. Contrast
11. Brightness
12. Reset the settings
13. Full screen
14. Confi gure pre-defi ned camera position if there is an alarm
15. (Not used on this camera)
Advanced settings:
WIFI settings
User settings
Alarm settings (an alarm must be connected
to your camera)
(possibility of managing recording using an
external alarm)
(possibility of using the camera to trigger an
external alarm)
Connect O'MOUV to the local network
Administrator
Operator
Activate the movement detector: Check the box to ac-
tivate the camera's movement detection
Detector sensitivity Defi ne the detection sensitivity
from 1 to 10 (10: minimum sensitivity,
1: maximum sensitivity).
Activate the alarm entry: Tick the box to activate the
incoming alarm via the terminal block at the rear
of the camera (5 Fig.3). the camera's alarm function is
triggered using a dry contact via terminals 3 and 4
Activate the IO link if there is an alarm: Tick the box
to activate the output "contact" via the terminal block
at the rear of the camera (5 Fig.3). When this option
is active the camera changes the dry contact status on
terminals 1 and 2.
Send an email when triggered
If activated, sends an email if there is an alarm
Alarm recording
Sends an image to the FTP server if there is an alarm
Enable the alarm sound: not used in this version
Upload image if triggered
Attach the image to the alert emails if there is an alarm
Loading interval if triggered
Interval at which images are sent via FTP if there is an
alarm
CFI EXTEL O'MOUV - 10/2015
F14