Extel O'MOUV Guide D'installation Et D'utilisation page 77

Restart
WIFI settings
FTP Settings: The FTP (File Transfer Protocol)
allows you to make a remote storage area lo-
cated on an FTP server accessible to an FTP
client (in this way you can access the hard disk
of a remote computer on your network or
via the Internet). Your IP camera can connect
to an FTP server and save image captures on
it (regular backup or if an alarm is triggered).
This section will allow your camera to know
the information required to access the desired
server.
User settings
Alarm confi guration using detection
(possibility of managing recording using an
external alarm)
(possibility of using the camera to trigger an
external alarm)
Email settings
SD card settings
Time settings
You can rename your camera at all times, click on "Edit" and modify
Reset factory settings
Confi gure the WIFI mode
FTP Server: Enter the FTP server's IP address.
FTP Port: Enter the FTP server port (by default port 21).
FTP User: Enter the name required for identifi cation.
FTP password: Enter the password required for identifi ca-
tion.
FTP loading interval: Select the time interval between each
sent image (1-3600s)
Administrator
Operator
Activate the movement detector: Check the box to acti-
vate the camera's movement detection
Detector sensitivity Defi ne the detection sensitivity from 1
to 10 (10: minimum sensitivity,
1: maximum sensitivity).
Activate the alarm entry: Tick the box to activate the in-
coming alarm via the terminal block at the rear of the cam-
era (5 Fig.3). the camera's alarm function is triggered using
a dry contact via terminals 3 and 4
Activate the IO link if there is an alarm: Tick the box to
activate the output "contact" via the terminal block at the
rear of the camera (5 Fig.3). When this option is active the
camera changes the dry contact status on terminals 1 and 2.
Send an email when triggered
If activated, sends an email if there is an alarm
Alarm recording
Sends an image to the FTP server if there is an alarm
Enable the alarm sound: not used in this version
Upload image if triggered
Attach the image to the alert emails if there is an alarm
Loading interval if triggered
Interval at which images are sent via FTP if there is an alarm
Sender: E-mail address of the sender.
SMTP server: SMTP message server.
SMTP Port: SMTP port of the sender used to connect to
the desired STMP server (by default most servers use port
25)
SSL: Depending on your SMTP server, by default none.
Recipient: Recipient's email address
CFI EXTEL O'MOUV - 10/2015
GB12