Worx WA0166 Notice Originale page 8

NOTE: When removing the battery pack, hold it
firmly to avoid dropping and injury.
WARNING: Do not stand directly below a
branch being cut. Keep bystanders far away.
Do not stand on a ladder or other type of unstable
support while using the tool. Do not use the tool
near cable, electrical power or telephone lines.
Keep 3m(10ft) away from all power lines. (See
Fig. G1-G4)
3. Use both hands to grip the pole saw. Use only
designated grip areas when operating pole saw (See
Fig. G5). Use firm grip. Thumbs and fingers must wrap
around pole saw handle and pole.
4. Make sure your footing is firm. Keep feet apart.
Divide your weight evenly on both feet.
5. When ready to make a cut, press the Lock-out But-
ton, then fully press the On/off Switch (See Fig. G6).
This will turn the pole saw on. Releasing on/off Switch
will turn the pole saw off. Make sure saw is running at
full speed before starting a cut.
6. When starting a cut, place moving chain against
wood. Hold pole saw firmly in place to avoid possible
bouncing or skating (sideways movement) of saw.
7. Guide pole saw using light pressure. Do not force the
pole saw. The motor will overload and can burn out. It
will do the job better and safer at the rate for which it
8
was intended.
8. Remove the pole saw from a cut with saw running
at full speed. Stop the pole saw by releasing trigger.
Make sure chain has stopped before setting the pole
saw down.
Chain saw extension pole EN