Worx WA0166 Notice Originale page 7

COMPONENT LIST
1. EXTENSION POLE HANDLE
2. LOCKING KNOB
3. CLAMPING LEVER
4. INNER POLE
5. LOCKING KNOB
6. EXTENSION POLE CONNECTION BRACKET
7. LOCK-OUT BUTTON
8. ON/OFF SWITCH
9. SHOULDER STRAP
TECHNICAL DATA
Length
Extension Length
Weight
SAFETY INSTRUCTIONS
WARNING:Read and understand all
instructions. Failure to follow all instructions
listed below may result in serious personal injury.
1. When using the extension pole to cut the branches
on a tree, make sure to keep a firm footing and bal-
ance. Do not stand in a position where the branch
may land after being cut.
2. When using this machine with the extension pole,
make sure to insert the battery pack to the pole
firstly.
OPERATING INSTRUCTIONS
NOTE:
Before using the tool, read the
instruction book carefully as well as the
instruction book of Chain Saw WG322E/WG323E.
This extension pole is designed for use with WORX
Chain Saw WG322E/WG323E.
ASSEMBLY
Warning:Before attaching the extension pole,
make sure that the battery pack has been
removed.
1. ASSEMBLING THE EXTENSION POLE
Align and insert the handle of extension pole into the
shaft. Rotate the locking knob clockwise to lock. (SEE Fig.
Chain saw extension pole
A1, A2)
NOTE: Make sure that the shaft is firmly
locked in place .
2. ASSEMBLING THE EXTENSION POLE TO
THE MACHINE (See Fig B)
Step1: Align and insert the pole connection bracket into
the saw.
Step2: Turn the locking knob counterclockwise to tighten
the extension pole to the machine.
NOTE: Make sure the extension pole is locked
into position securely before operation.
3. REMOVING THE EXTENSION POLE (See Fig. C)
Step1: Turn the locking knob clockwise to loosen and pull
it out.
Step2: While pulling the locking knob then slide saw to
disconnect the extension pole with the saw.
WARNING! When using the Extension Pole,
make sure that the battery pack has been
removed.
4. ADJUSTING POLE LENGTH
2m
The pole saw has a telescoping pole assembly that
0.7m
will extend from 2m (fully retracted) to 2.7m (fully
1.9kg
extended).
Clamping lever is used to hold the pole in position at
any extended length.
1. To extend the pole, loosen the clamping lever as
shown in Fig D. Pole will slide freely.
2. Pull inner pole section out to desired length of ex-
tension. Note: only extend pole to minimum length
required to reach limb that is being cut.
3. To lock pole in position, tighten clamping lever as
shown in Fig. D.
Cutting with shoulder strap (See Fig. E)
The extension pole is supplied with a shoulder strap
that gives extra support when hoisting the pole saw in
the air. Hook the shoulder strap to the extension pole
and wrap around your shoulder. The shoulder strap can
also soften the impact if the pole saw is dropped after
the completion of a cut.
WARNING! ELECTROCUTION HAZARD
Never use the chain saw or extension pole
in an area with overhead power lines or where
the branch being cut can come into contact with
overhead power lines.
CUTTING WITH EXTENSION POLE
1. Attached the pole as described in ''Assembly''.
2. Install the battery pack into the machine.
NOTE: Your battery pack maybe UNCHARGED and you
must charge it before usage. Depress the battery pack
release button to remove the battery pack from your
tool (See Fig. F1). After recharging, insert the battery
pack into the battery port. A simple push and slight
pressure will be sufficient until a click is heard (See Fig.
F2). Check to see if the battery is fully secured.
7
EN