Télécharger Imprimer la page

Frico IRCF Instructions De Montage Et Mode D'emploi page 13

Publicité

Les langues disponibles
  • FR

Les langues disponibles

GB
- During operation the surfaces of the unit
are hot!
- The unit must not be covered fully
or partially with clothes, or similar
materials, as overheating can result in a
fire risk!
- Ensure that there is no excessive build-up
of dust/dirt on or around the heater as this
can cause overheating.
- A safety distance of not less than 1 m to
inflammable substances should always be
left in front of the heater.
Maintenance
During maintenance the heater must be
disconnected from the power supply.
The heater contains no moving parts
and therefore very little maintenance is
required other than to ensure that there is no
excessive build-up of dust/dirt on the reflector
or lamp as this can cause overheating and
premature lamp failure.
To clean the appliance, wipe off with a damp
cloth. Wait until the unit is completely dry
before connecting it to the power supply.
When cleaning the appliance a mild soap
solution can be used. (N.B. Dishing- or
washing detergents can do damage to the
reflectors)
12
IRCF
Replacement of lamp
A qualified person shall replace the lamp and
the gaskets.
The lamp is robust and if knocks and shock
vibrations are avoided it will run for a long
time. The expected lifetime of the lamp is
depending on the ambient temperature and
where the heater is installed.

Publicité

loading