Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Cleaning the appliance:
Never use abrasive cleaners
Before cleaning the appliance it should be disconnected from the power supply.
Cleaning the work surface: periodically clean the burner heads, the enamelled steel pan supports and the
burner caps using warm water.
Any spillage must always be removed as soon as possible using a rag.
If it become difficult to open or close a valve, do not force it, but immediately request the assistance
of the technical service personnel.
Cleaning the griddle: Thoroughly clean the griddle of grease and food particles, using a square-edged
spatula, while it is still hot. While the griddle is still hot, pour a small quantity of a solution of warm water and
vinegar over it and rub gently with a cloth an a spatula. This will ease the removal of food particles. Wipe the
griddle with a dry, heavy, coarse cloth to remove any remaining residue and food particles. Wash with hot
soapy water, rinse and dry . Once the griddle has cooled, rub the surface lightly with vegetable oil. Do not
use corn oil or cooking sprays as they get sticky. If the gridlle is cleaned with anything other than a dry,
heavy, coarse cloth, it will need to be reseasoned. Never flood the hot griddle with cold water. This could
cause the griddle to crack or warp.
Do not touch the griddle when it is hot
Note: do not use the scouring sponge to clean the stainless-steel frame, this will leave scratch marks. Do not
use metal pot cleaners, steel wool, wire brush or similar.
Some food can leave white marks after cleaning the appliance. You can remove these marks using lemon
juice.
Cleaning the enamelled parts: Enamelled parts should be cleaned frequently with soapy water. Never use
abrasive powder. Do not leave acidic or alkaline substances on the enamelled parts (such as vinegar, lemon
juice, salt, tomato sauce, etc.) and do not wash the enamelled parts while they are still hot.
Cleaning the stainless steel parts: Clean the parts with soapy water and dry them with a soft cloth. The shine
is maintained by periodically using suitable products which can be found in the supermarket. Never use
abrasive powders.
Cleaning the burner caps: Lift the burner caps from the burner heads and wash them in soapy water and
dry thoroughly. Before replacement on the burner head ensure that the holes are not clogged.
After sale service:
Dealer /Importer:
Name, address, phone
SERVICE CENTERS
Name
Phone
MANUFACTURER:
BERTAZZONI SPA
VIA PALAZZINA, 8 – 42016 – GUASTALLA (REGGIO E.) ITALY
Tel. 0522/226411 – telefax 0522/226440 –
http://www.bertazzoni-italia.com
12
Publicité
Chapitres
Table des Matières
