Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5 OPERATION

The device should power up and be ready in a few seconds. The LEDs should blink in the following manner.
The green "Alive" LED should start to blink approximately once per second.
The yellow RS485 TX and RX LEDs will blink for local Modbus activity.
The red input status LEDs will blink when input contact closures are detected. Input status LEDs are
adjacent to the corresponding input screw terminals.
If the A8911-23 is attached to an AcquiSuite Data Acquisition Server, you will need to configure each pulse
input with a Name, Engineering Unit, and Multiplier.
6

Publicité

Table des Matières
loading

Table des Matières