Lighting Operation Instructions - Dyna-Glo HEATAROUND360 HA1360R-01 Manuel De L'utilisateur Et Instructions D'utilisation

LIGHTING, OPERATION, AND
SHUTDOWN INSTRUCTIONS
1. Make sure the control knob is in the OFF position. " "
2. Open the access door and install the propane fuel source;
a. Install a DOT certified 1 lb. propane cylinder.
b. Install the GHP hose connector model #
Check for gas leaks by using a 50% soap-water solution at
the joint of the regulator and cylinder.
3. Depress and turn the control knob to the pilot position " ".
a. If fueled by a 1 lb. propane cylinder, hold for 30 seconds.
Push and turn knob back to the off position. From the OFF "O" position,
push and turn counter clockwise to the PILOT position. " ". The Igniter
will spark each time this step is performed. Repeat until the pilot flame
lights.
4. Continue holding the knob down in the PILOT position
for 30 seconds or until pilot flame holds.
5. Release the knob. The knob should return to the fully
extended position and the pilot should remain lit.
6. Turn on the burner by depressing the knob slightly and
gently turn the knob to the HI position " ".
7. Adjust heat output by turning the knob between HI and
LOW position " ".
8. To shut down the heater turn the knob clockwise to the OFF
position and remove the gas cylinder or close the propane
tank shut off valve and allow the heater to burn off the gas in
the hose, then turn the heater knob to the OFF position.
CAUTION
Do not try to adjust heating levels by using the propane tank shutoff valve.
After turning heater off the guard will remain hot. Allow the heater to cool
down before storing the heater.
Do not operate, store, connect or remove cylinder/hose connection near
flammable items or ignition sources.
LIGHTING IN WINDY AREAS
1. Position the heater such that the Pilot is opposite the direct that the
wind is coming from.
2. Position your body behind the heater such that your body blocks the
wind while you are following the instructions for lighting the unit.
HAKITDG.
6
Pilot Position
HIGH Position
LOW Position
Fig. 2 - Lighting Instruction
Fig. -Lighting Instructions
WIND DIRECTION
Fig. 3 - Lighting in Windy Areas
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
Knob Indicator Mark
OFF Position
Control Knob
PILOT POSITION