Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
WARNING: The heater must be properly installed before use.
Set thermostat to its full counterclockwise position. Plug the unit into a properly
grounded 240V outlet. Set the thermostat to the farthest clockwise position. The fan
should come on and the unit will start heating the room. When the room reaches
comfort level, turn the thermostat counterclockwise until the heater turns off.
The heater will cycle automatically around this preset temperature. To increase
temperature, turn the thermostat knob clockwise. To lower temperature, turn the
thermostat counterclockwise.
WARNING: Do not tamper with the thermostat
or high limit.
NOTE: Unplug the unit when not in use.
WARNING: DISCONNECT POWER BEFORE SERVICING.
OPERATING INSTRUCTIONS
CIRCUIT DIAGRAM
Power Indicator lamp
Black wire
Blue wire
Red wire
White wire
Green wire
OFF/ÉTEINDRE
Caution Indicator lamp
Heater's
thermostat
Blue wire
Black wire
5
LOW/BAS
THERMOSTAT
Red wire
Black wire
Overheating
Black wire
protection Switch
Blower Motor
Black wire
Black wire
HIGH/HAUT
Heater
Publicité
Table des Matières
