4 Maintenance
Maintenance must be carried out by competent personnel.
It is recommended that the following maintenance is carried out annually:
• Visually inspect the foot shell and glide sock, check for damage or wear and replace
if necessary.
There are no other serviceable parts in the foot assembly.
The wearer should be advised:
Any changes in performance of this device must be reported to the practitioner
Changes in performance may include:
• Increase in ankle stiffness
• Reduced ankle support (free movement)
• Any unusual noise
Cleaning:
Use a damp cloth and mild soap to clean outside surfaces, DO NOT use aggressive
cleansers.
5 Limitations on use:
Intended life:
A local risk assessment should be carried out based upon activity and usage if usage is
beyond recommended activity level.
Lifting loads:
User weight and activity is governed by the stated limits.
Load carrying by the user should be based on a local risk assessment.
Environment:
The Avalon
is water proof to a maximum depth of 1 metre.
K2
Thoroughly rinse with fresh water after use in abrasive environments such as those that
may contain sand or grit, for example, to prevent wear or damage to moving parts.
Thoroughly rinse with fresh water after use in salt or chlorinated water.
Foot products must be adequately finished to prevent water ingress into the foot shell
where possible. If water enters the foot shell, the limb should be inverted and dried
before further use.
Exclusively for use between -15˚C and 50˚C.
It is recommended that only Endolite products be used in conjunction with the
Avalon
.
K2
4
938327/5-0116