hestan KRG Mode D'emploi page 32

CARE & MAINTENANCE
Do not rub, disturb or damage the cloth-braided door gasket. If the gasket is damaged, it will need to
be replaced. Use only Hestan genuine replacement parts.
Wait until the appliance is completely cool before using any aerosol-type cleaners. Many of these
EN
cleaners use flammable propellants which could ignite in the presence of heat.
LADDER RACKS / OVEN RACKS LADDER RACKS / OVEN RACKS
The oven racks and the left & right ladder racks can be removed from the oven for cleaning.
The racks may be cleaned with warm soapy water, or any number of commercial stainless steel
cleaners. Check to make sure the cleaners do not contain chlorine or chlorine compounds as these
are corrosive to stainless steel. Rinse thoroughly. If the racks do not slide easily after cleaning, apply
a small amount of food-safe or cooking oil to the slide rails.
SUGGESTED CLEANERS:
Hot water & mild detergent
Vinegar & water
Fantastik
Bon-Ami
Kleen King
SoftScrub
SEALED BURNERS SEALED BURNERS
BURN HAZARD - To prevent burns, do not touch the burner heads or cooking grates when hot.
Allow to cool completely.
The burners can be disassembled for cleaning. Use only a small toothbrush to clean the burner ports
and igniter. DO NOT insert sharp objects or scratch the burner ports. After cleaning, ensure the
sealed burner heads are properly installed and seated on the burner base as shown below. There are
notches on the burner base and cross ring to help with alignment. The outer burner head features
a long slot on the top of the head which aligns with the spark igniter. Assembly of the single-flow
burner head is similar.
OUTER
BURNER
BEAUTY
30
©2021 Hestan Commercial Corporation
®
®
®
®
INNER
BURNER
HEAD
HEAD
RING
DUAL FLOW
BURNER
(CONTINUED)
CROSS
RING
BURNER
BASE
SINGLE FLOW
BURNER
BURNER
RING
BURNER
HEAD
BURNER
BASE
IGNITER