Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
VOKKERO GUARDIAN EUROPE Wireless Interface (WI) - User Guide V0.1.0
4. AUDIO CONFIGURATION
4.1. Configuration with 4-wire Intercom systems
The WI interface is designed to be connected to a 4-wire intercom. Below you will find 2 configuration examples:
4.1.1.
Clearcom 4-wore interface
•
Connect a cable between the green connector of the clearcom interface and two XLR 3 pts male and female.
In order to identify the cabling, refer to the Clearcom IF4W4 user guide.
•
Connect an XLR 3 pts cable (male/female) between the "OUT1" connector of the 4-wire interface system and the "IN" connector of the
Vokkero Guardian wireless interface.
•
Connect an XLR 3 pts cable (male/female) between the "IN1" connector of the 4-wire interface system and the "OUT" connector of the
Vokkero Guardian wireless interface.
•
Connect the Vokkero Guardian wireless Interface power cable to another power supply.
Power source
Power source
Power source
Power source
These cables are not included in the kit
Pin 2
Pin 3
Pin 2
Pin 3
Connect the adapteur as follows:
Pin 1--- Common
Pin 2 --- Line 1
Pin 3 --- Line 2
GB
Mains
outlet
cable
Page
33
/ 52
Publicité
Table des Matières
