Child Lock; Timer Function - Sharp KH-6I19FTPP-EU Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Heat setting
1 - 2
3 - 4
5
6 - 9
Child Lock:
The child lock function can be activated
after switching the control on. To
activate the child lock, simultaneously
operate the front increase heat setting
key
and the decrease heat
setting key
increase heat setting key
"L" meaning LOCKED will appear in
all heater displays and the control can
not be changed. (If a cooking zone is
in the hot condition, "L" and "H" will be
displayed in alternation.)
The hob will remain in a locked
condition until it gets unlocked, even if
the control has been switched on and
off.
To deactivate the child lock, first switch
the hob on. Simultaneously operate
the front increase heat setting key
and the decrease heat setting key
and then operate the decrease heat
setting
key
again. "L" will disappear in the
display and the hob will be switched
off.
Safety switch
off after
6 Hours
5 Hours
4 Hours
1,5 Hours
and then operate the
again.
Key Lock
Key lock functionality is for blocking
and setting the appliance into safe
mode during operation. Touch
modifications as, for example,
increasing heat settings and others
should not be possible. Only switching
the appliance off is possible.
The lock function becomes active if
the Key Lock button
for at least 2 seconds. This operation
is acknowledged by a buzzer. After
a successful operation of more than
2 seconds, the Key Lock Indicator
flashes and the heater becomes
locked.
Timer function :
The timer function is carried out in two
versions:
Minute minder timer (1to 99
minutes):
The minute minder timer can be
operated if the cooking zones are
switched off. The timer display displays
"00" with a blinking dot.
Press the timer setting key
increase the time or press
decrease the time. Adjustment range
is between 0 and 99 minutes. If there
is no operation in 10 seconds, the
minute minder timer will be set and
the blinking dot will disappear. After
the timer is set, the time runs down
according to the adjustment.
When the time is over, a signal sounds
and the timer display blinks. The sound
EN - 10
is pressed
to
to

Publicité

Table des Matières
loading

Table des Matières