SpeedEPart Agri-Fab 45-0298 Notice D'utilisation page 5

For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
7. Assemble a single spool assembly, a " long spacer, a
double spool assembly, a .33" long spacer and a 3/4"
flat washer onto the short end of the shaft. See figure
4.
1.33" LONG
3/4" FLAT SPACER (T)
WASHER (O)
DOUBLE SPOOL
ASSEMBLY
SINGLE SPOOL
ASSEMBLY
FIGURE 4
8. Assemble a 2.38" long spacer, a 3/4" flat washer, the
middle brace, a 3/4" flat washer, a 3.70" long spacer,
a single spool assembly, a .33" long spacer, a double
spool assembly, a 1.33" long spacer and a 3/4" flat
washer onto the long end of the shaft. The bent lip of
the middle brace must face the short end of the shaft.
See figure 5.
2.38" LONG MIDDLE
SPACER (Q) BRACE
3.70" LONG
SPACER (R)
3/4" FLAT
WASHER (O)
SINGLE SPOOL
ASSEMBLY
DOUBLE SPOOL
ASSEMBLY
FIGURE 5
1" LONG
SPACER (S)
SHORT END
1.33" LONG
SPACER (T)
1.33" LONG
SPACER (T)
3/4" FLAT
WASHER (O)
www.mymowerparts.com
ENGLISH
9. Assemble an end plate to the end of the tray using four
5/6" x 3/4" hex bolts and four 5/6" nylock nuts. Repeat
for other end. Do not tighten till step 20. See figure
6.
5/16" NYLOCK
NUT (K)
FIGURE 6
0. Assemble the tongue to the tray, placing the slot's lock-
ing notch to the front. Use two 3/8" x " hex bolts, two
3/8" x -/4" hex bolts, four /4" long spacers, and four
3/8" nylock nuts as shown in figure 7. Tighten.
3/8" x 1"
HEX BOLT (D)
1/4" LONG
SPACERS (P)
LOCKING
NOTCH
FIGURE 7
5
5/16" x 3/4"
HEX BOLT (E)
3/8" x 1-1/4"
HEX BOLT (C)
3/8" NYLOCK
NUT (J)