Portamate PM5000 Manuel De L'utilisateur page 6

11
Attaching Machine Mounts*:
From the bottom, pass the M8 x 63mm
carriage bolt O through the slot in the machine
mount and secure with flat washer P,
lock washer Q, and nut R. Repeat with all
mounting holes. Hand tighten only.
Note: For easier installation and removal, place
spring mounted handles in rear of machine.
12
Carefully lift the saw and place onto the
stand. Lock your machine mounts as shown
in Step 13.
Slide your saw forward or backward along
the machine mounts to best balance the
saw stand. Secure the saw by tightening the
carriage bolts O.
13
Note: Machine is locked into position when both the front and
the back of the machine mounts are secure as shown.
14
Adjust roller supports so rollers are on
the same plane as the work surface of
your machine.
*
For machines with offset mounting hole patterns (such as 3-hole or inset holes),
some models come with a hardware kit adapter. See the following page for
installation instructions and how to order.
6