Displaying Setting Values (When Dip Switch S100-2 Is On); Changing The Display - Sony HKDV-900 Mode D'emploi

Displaying Setting Values (When DIP Switch
S100-2 Is ON)
You can display the setting value for each adjustment
of the output signals and image enhancer in the
MEMORY ADDR. indicator in the memory section.
To display the values
Set DIP switch S100-2 on the internal board to the ON
position.
For details of the settings of the DIP switches, refer to
"6-2. Setting the Switches on Board," in the installation
manual.

Changing the display

There are two methods of achieving this, as follows.
Turn an adjustment knob
The displayed item changes.
Press the –/+ buttons
Without the values changing, the displayed item
changes.
The level indicator (green) for the adjustment knob
corresponding to the displayed item flashes.
Adjustment value display section
(MEMORY ADDR. indicator)
–/+ buttons
When you press the STORE or LOAD button, until the
save or recall operation is completed, the MEMORY
ADDR. indicator shows the memory address.
Note
When the output selection buttons are pressed, the
contents of the selected item are displayed.
STORE button
LOAD button
CANCEL button
11(GB)