Overview - Sony HKDV-900 Mode D'emploi

Overview

Overview
The HKDV-900 connects to the HDW-500/F500/
2000/M2000/A2100/M2100 HD (high definition)
Digital VTR and controls the HD/SD (standard)
output video signals and the image enhancer of the
down-converter built into the VTR.
It can also be used as a remote controller for the
HKPF-525 HD-NTSC Down-Converter Board,
HKPF-1125 525-HD Up-Converter Board, and
HKPF-9000 Multi-Format Converter Board fitted to
the PFV-series Digital Video Interface Units.
The following are the principal features of this
product.
Video output adjustments for both HDTV
and SDTV
It is possible to adjust the HD/SD output from the
HDW-500/F500/2000/M2000/A2100/M2100, the HD
output from the HKPF-1125, and the HD/SD output
from the HKPF-9000.
The parameters which can be adjusted for each output
are as follows:
HD: Y (luminance) level, P
levels, master level, setup level, sync phase
D1: Y level, B-Y/R-Y levels, master level, sync
phase, cross color
D2: video level, chrominance level, setup level,
sync phase, hue, cross color
Down/up-conversion mode selection
The following three modes can be selected for down-
conversion and up-conversion mode, respectively:
• CROP mode (the sides of the HDTV image are lost)
• LETTER BOX mode (the HDTV image appears in a
slot with its aspect ratio unchanged at 16:9)
• SQUEEZE mode (the HDTV image is compressed
horizontally)
Down/up-converter image enhancer
adjustment
This adjusts the image enhancer built into the HDW-
500/F500/2000/M2000/A2100/M2100, HKPF-525,
HKPF-1125, or HKPF-9000. The following items can
be adjusted:
2(GB)
/P (color difference)
B R
H CROP•V LETTER: horizontal position for
cropping in the edge crop mode with a down-
converter, and horizontal position of the HDTV
image in the edge crop mode and vertical position
for cropping in the letter box mode with an up-
converter
DETAIL GAIN: sharpness of edge enhancement
LIMITER: maximum limit to detail added to
enhance original signal
CRISP: amplitude setting for not enhancing small-
amplitude signals
DEPEND: luminance range for edge enhancement
FREQUENCY: center frequency for edge
enhancement
H/V RATIO: ratio of horizontal and vertical edge
enhancement settings
GAMMA: gradient of gamma correction curve
RS-422 remote control
You can use an optional 9-pin remote control cable
(RCC-5G/10G/30G) for direct connection to control
the HDW-500/F500/2000/M2000/A2100/M2100,
HKPF-525, HKPF-1125, and HKPF-9000.
Memory function for adjustments and
settings
Up to 99 sets of settings can be saved in memory and
recalled as needed. Each set consists of the settings for
each output signal and the system settings.
Display function for adjustments and
settings
If DIP switch S100-2 on the internal board is set to the
ON position, you can display the setting value for each
adjustment in the MEMORY ADDR. indicator in the
memory section.
For details of the settings of the DIP switches, refer to
"6-2. Setting the Switches on Board," in the installation
manual.
Video output adjustment of up to four
external devices
Up to four external devices can be connected to the
HKDV-900 and their respective video output can be
adjusted individually.