Usage Of The Controller; Setting Temperature - Hayward HP50CLEE Manuel D'installation Et D'instructions

4. USAGE
4.2. Usage of wire controller
4.2.1
Turn ON/OFF the unit
When the unit is off, press the key"
When the unit is on, press the key"
Standinterfaceby
4.2.2

Setting temperature

In the running interface，press"
then press" "to increase the temp.value, or press"
save setting parameter but back to the main interface; Attention：If there is no operation for
5s，system would remember parameter setting and back to the main interface. In the main
interface，press"
display is back to the main interface after 10s.
System will save user's
setting and return back
Press" "2s
to main interface if there
is no operation in 5s.
"0.5s to turned on the unit;
"0.5s to show down the unit.
Press" "0.5s
Press" "0.5s
"or"
"for 2s you can see the outlet temp.The parameter is then flashed and the
Press"
or " "
Outlet Temp.
Running interface
"then the current mode target-temperature flashes,
"to decrease it. Press"
"
Press" "
Heating/ Cooling
actual water Temp.
"will not
Heating/ Cooling
Target Temp.
Press" "
Heating/ Cooling
Target Temp.
10