Technical Data; Assembly - Hilti UH 240-A Mode D'emploi

5. Technical data

Tool
Rated voltage
Weight of tool including battery and chuck
Dimensions (L×H×W)
Speed
Chuck / clamping dia. range (quick-release chuck)
Torque
Torque adjustment
Speed control
Forward / reverse
Spindle lock
Motor brake
Gearing section sealed to prevent entry of dust and with permanent lubrication (maintenance-free)
Battery
Rated voltage
Battery capacity
Weight
Temperature monitoring
Type of cell
No. of cells
Right of technical changes reserved!

6. Assembly

1. It is essential that the safety precautions printed in
these operating instructions are read and observed.
2. It is essential that a new battery is charged correctly
before initial use so that the battery cells can form
correctly. Incorrect initial charging can lead to a per-
manent reduction of battery capacity.
– With the C 7/24 charger: Charge for 24 hours in nor-
mal charging mode or for 12 hours in conditioning
mode.
– With the C 7/36-ACS charger: The charger detects
automatically whether initial charging or normal
charging is necessary.
-NOTE-
The tool may be used only with B24/2.0 NiCd, B24/2.4
G
NiCd or B24/3.0 NiMH batteries.
Battery performance drops at low temperatures.
G
Printed: 07.07.2013 | Doc-Nr: PUB / 5071285 / 000 / 00
24 V –––
- - -
3.8 kg (8.3 lb)
320x286x92 mm (12.6x11.2x3.6 in)
1 st gear: 0– 350 r.p.m.
2 nd gear: 0– 1300 r.p.m.
3 rd gear: 0– 1950 r.p.m.
1.5–13 mm (0.06–0.5 in)
Max. 45 Nm (at drilling setting)
5–17 Nm (in 15 increments)
Electronic control switch
Electrical switch with interlock to prevent activation
when running
When control switch is in the "off" position
By way of the control switch
B24/2.0 NiCd B24/2.4 NiCd
24 V ––– 24 V –––
- - - - - -
24 V × 2.0 Ah 24 V × 2.4 Ah
= 48 Wh = 58 Wh
1.38 kg (3.0 lb) 1.38 kg (3.0 lb) 1.45 kg (3.2 lb)
yes yes
Nickel-cadmium Nickel-cadmium Nickel-metal hydride
SUB C type SUB C type
20 20
Batteries should be stored at room temperature.
G
Never store batteries where they are exposed to the
G
heat of the sun, on a radiator, behind a motor vehicle
windscreen or at a window.
Never use the battery until the cells become fully dis-
G
charged. Change to the second battery as soon as a
drop in performance is noticed and recharge the bat-
tery immediately so that it is ready for re-use.
Use bits with a standard
G
6.1 Fitting the side handle
1. Open the side handle clamping band by turning the
handle.
2. Slide the side handle clamping band over the chuck
and onto the tool.
3. Pivot the side handle into the desired position.
4. Secure the side handle by turning the handle.
B24/3.0 NiMH
24 V –––
- - -
24 V × 3.0 Ah
= 72 Wh
yes
SUB C type
20
" hex. shank.
1 /
4
en
5