Sumiko W. TRANSIMTTER Instructions D'utilisation page 15

SUMIKO W. TRANSMITTER UNIT - REAR PANEL
FIG. 2
1. Supply voltage input (5Vdc).
2. Line Input: by using an RCA terminated cable,
allows the connection of the Transmitter to the
line output of an AV player (DVD, Blu-ray, etc) or
amplifier (see fig. 4).
3. LFE Input: by using an RCA terminated cable,
allows the connection of the Transmitter to the
LFE (Low Frequency Effects) output of an AV
player (DVD, Blu-ray , ecc.) or a home theatre
controller/preamplifier (see fig. 4).
Pairing: to be used during the installation
procedure. Keep it pushed – normally for about
10 seconds – until the light indicator starts
blinking faster. When this happens push – within
maximum 30 seconds – the pairing pushbutton
on the receiver unit(s) or the Sumiko subwoofer
incorporating this device. The radio link(s) will be
established when the light indicators on the units
stop blinking.
1 2 L1 3 4
A single transmitter can support up to 4 radio
links with the same amount of receivers (Sumiko
receivers and/or Sumiko Subwoofers with
integrated receivers).
5. Speakon © Connector: by using a Speakon©
properly terminated cable (like the one supplied
with Sumiko Subwoofers), allows the connection
of the transmitter to the speaker outputs of a
stereo integrated or power amplifier.
L1. Light indicator: if fixed shows if the unit is
powered and matched to the receiver unit(s). The
light is blinking during the pairing procedure or if
the radio link is not achieved yet.
5