Cleaning And Maintenance; Troubleshooting - FAR TI16 CI Manuel D'utilisation

ENGLISH

CLEANING AND MAINTENANCE

1. Unplug the appliance before cleaning and
maintenance.
2. Wipe the outside, the hotplate and the control
panel with a soft, damp cloth. You can use a
neutral cleaning product to remove worn-on
greasy stains, and then wipe away the residue
with a soft, damp cloth.
3. Never rinse the appliance with water and never
submerge it in water.
4. Clean the appliance regularly. Ensure no
insects enter the appliance through the fan
vents, as they could cause it to break. Remove
dust and stains from the vents using cotton
buds. You can also clean it by putting a small
amount of detergent on a toothbrush.
ENERGY EFFICIENCY COMPARISON TABLE
(for 1 litre of water)
Type of Electricity or gas
Duration
hotplate
Induction 6.7 minutes
Gas 8 minutes
Electricity 12 minutes
GB-12
Cost Heat efficiency
consumption
0.2 kW/h 0.140 RMB 93%
0.05 kg 0.185 RMB 50%
0.345 kW/h 0.250 RMB 47%

TROUBLESHOOTING

If there is a problem during use, carry out the following checks before contacting the
after-sales team.
PROBLEM CHECK
Even though the appliance Check that the plug correctly inserted into the
is plugged into an electrical electrical socket.
socket, it does not beep and
Check that a fuse has not been blown in your
none of the lights turn on when
house and that the circuit breakers haven't been
you press the ON/OFF button.
tripped.
Check that the socket is switched on.
The appliance sounds Check you are using a suitable cooking vessel.
continuously for 15 sec, then
Check that the cooking vessel is placed in the
stops working.
centre of the cooking area.
Check that the base diameter of the cooking
vessel is between 12 and 18.5 cm.
The appliance suddenly Check that the room temperature is not too
switches off while cooking. high.
Check that the fan vents are not blocked.
This means that the set temperature has been
reached when the appliance is in keep warm
mode.
The protective system may have been triggered.
Wait 10 minutes then try again.
The temperature is not The bottom of the cooking vessel is concave/
controlled properly when convex, or the middle of it is.
cooking or keeping warm.
Check that the ON light is lit.
If there is a problem, the appliance will stop working and after 3 seconds an error
code will be displayed in the middle of the screen. Press the ON/OFF button to
make the error code disappear and put the appliance in standby mode.
ENGLISH
GB-13