Ego Power+ LM2130SP Guide D'utilisation page 53

PROBLEM
The mower
does not
mulch properly
The mower
stops while
mowing
There is
excessive
vibration
The handle-
locking clamps
cannot be
closed in
position
56-VOLT LITHIUM-ION CORDLESS LAWN MOWER — LM2130SP/LM2130SP-FC/LM2130/LM2130-FC/LM2150SP/LM2150SP-FC
CAUSE
◾
Wet grass clippings are sticking
to the underside of the deck.
◾
The mower is set to cut too much
grass at once.
◾
The battery pack is depleted.
◾
Mower is in overload condition.
◾
Mower deck is clogged with
grass and debris.
◾
The battery pack or mower
circuitry is too hot (The power
indicator on the mower emits an
orange light for 10 seconds).
◾
The side rail is retracted a little
by the pushing force applying on
the handle.
◾
The cutting blade is loose.
◾
The cutting blade set is
unbalanced.
◾
The cutting blade is bent.
◾
The motor shaft is bent.
◾
The mower is set to cut too much
grass at once.
◾
The side rails are not fully
extended.
SOLUTION
◾
Wait until the grass dries before
mowing.
◾
Raise the deck to a higher
cutting-height setting.
◾
Charge the battery pack.
◾
Raise the cutting height or slow
down the mowing.
◾
Unclog the mower deck. Raise
the cutting height and/or cut a
narrower swath.
◾
Allow the battery pack or mower
to cool until the temperature
drops below 152°F (67°C).
◾
Unlock the clamps. Fully extend
the side rails and lock the
clamps again.
◾
Tighten the outer nut.
◾
Balance the blade set following
the"SHARPENING THE BLADE".
◾
Replace the blade.
◾
Contact the service center.
◾
Raise the deck to a higher
cutting-height setting.
◾
Fully extend the side rails, then
lock the clamps.
53