8
ENGLISH
Always have the tanning lamps and starters replaced by a service centre authorised by
Hapro. Only they have the knowledge and skills required for this job and the original spare
parts for your face tanner.
Additional or replacement goggles can be ordered at your local dealer.
Environment
● The lamps of face tanners contain substances that may pollute the environment. When
you discard the lamps, do not throw them away with the normal household waste, but
dispose of them at an official collection point.
● Do not throw the appliance away with the normal household waste at the end of its life,
but hand it in at an official collection point for recycling. By doing this you will help to
preserve the environment. (Fig. 4)
Guarantee & service
All defects resulting from material or production faults and which occur within the warranty
period, will be repaired free of charge on production of the original sales invoice. The warranty
period is 24 months. For warranty queries, please contact your dealer.
Your new face tanner is intended for domestic use and not for commercial purposes. Damage
as a result of commercial use, as well as tubes, starters, protective supports and acrylic panels,
are not covered by the Hapro warranty.
Malfunctioning as a result of assembly and or installation faults, improper use, lightning
damage and non-original parts are excluded from the Hapro warranty.
Check carefully if the equipment has been installed properly before claiming under the
warranty. In case of an unwarranted claim, you will be charged service costs.
Troubleshooting
If problems should arise with this appliance and you are unable to solve them by means of the
information below, please contact the nearest Hapro dealer.
Problem
The appliance does
not start.
Poor tanning results.
Solution
Make sure the plug has been properly inserted into the wall socket.
There may be a power failure. Check if the power supply works by
connecting another appliance.
You are not following the tanning schedule suitable for your skin
type. Check the table in section 'Tanning sessions: how often and
how long?' .
The distance between the lamps and your face is larger than
prescribed.
When the lamps have been used for a long time, the tanning
capacity will decrease. This effect only becomes noticeable after
several years. You can solve this problem by selecting a slightly
longer tanning time or by having the tanning lamps replaced.