Pfannenberg DTT 6101 Série Instructions D'utilisation page 75

GB
Assembly with quick-release frame
Install the cooling unit on the quick-release frame
3
Figure28 - Quick-release frame/switch cabinet
assembly
Procedure
 Position the quick-release frame (1) on the assembly cut-out (2).
 The assembly cut-outs and fastening points are identical to those for assembly of the cooling unit alone; see the
figure "Easy-Cut" or "- Performance-Cut cut-outs".
 Fasten the quick-release frame with screws and casement fasteners (3) on the switch cabinet from the inside;
see the figure Quick-release frame/switch cabinet assembly.
 When retrofitting, use the screws and casement fasteners which fastened the cooling unit; see the figure
Loosening the front panel.
 Insert the cooling unit in the quick-release frame (4).
 Lock the cooling unit in the quick-release frame. Use the wrench (5) provided for this purpose.

The DTT cooling unit is attached and ready for electrical connection.
Operating Manual DTT 6101 / 6201 Multicontroller (MC) 086100023 © Pfannenberg GmbH
1
2
4
Figure29 – Quick-release frame/switch cabinet/cooling
5
unit assembly
Page 26 / 49