Error Messages - Halley Home Run 2.0 Mode D'emploi

· Calories: Displays the distance covered during the session between 0.00 and 99.99 km, if no calorie consumption target
has been set. If you have set a calorie consumption target, when you start the session the countdown will start from the
target set to 0.
· Heart rate: The monitor will display your heart rate during the session in values between 40 and 180 beats per minute if
no training target has been set.
Buttons
· Up-Down/Enter: To adjust settings and navigate through the computer menus, turn the button. To confirm the settings,
press the button. Use this button to adjust the incline.
· START: Press the key to switch on the computer. If you press START during the session, the treadmill will stop and the display will go
into pause mode. To resume the session, press START.
· STOP: Press stop to finish the session. The settings will return to default.
· Warm Up: Press the key to start the manual programme (P1). This is the default programme. · Fat
Burning: Press the key to start the fat burn programme (P2).
· Heart exercise: Press the key to start the heart exercise programme (P3).
· Lose Weight: Press the key to start the lose weight programme (P4).
· Long Distance Run: Press the key to start the long distance programme (P5).
· Enhanced Training: Press the key to start the long distance programme (P5).
· User Prog: Press the key to start the customised programme (P7).
· Safety Key: The equipment does not work without the safety key. If the safety key is removed during the session, the
treadmill will stop.
· INCLINE (Left handlebar): Adjust the incline and the settings flashing on the display.
· SPEED (Right handlebar): Quickly adjusts the speed and settings that are flashing on the screen.

Error messages

Display E01
E01: There is a problem with the connection between the computer and the controller.
SoluTIOn: Check the four-pin connector cable between the computer and the controller is not loose or
defective.
Display E02
E02: Shows that the voltage line from the motor is not being checked by the controller.
SoluTIOn: Check that the motor cable is properly connected to the controller.
Display E03
E03: The speed information is not reaching the computer.
SoluTIOn: Check that the hole in the disc of the motor is properly aligned with the light and the sensor.
Display E05
E05: Indicates that the belt friction is too tight for the motor to function correctly.
SoluTIOn: Check that the belt is properly lubricated. if the error persists, contact the technical service.
Home Run 2.0
25