Operation Without The Remote Control Unit; Care And Cleaning; Air Filter - Technibel MPAF13A0R5I Série Notice D'utilisation

3742540582-USO-TEC-MPAF13A-B
OPERATION WITHOUT THE REMOTE
CONTROL UNIT
If you have lost the remote control unit or it has troubles,
follow the steps below.
1. WHEN THE AIR CONDITIONER IS STOPPED
If you want to turn on the air conditioner push the
OPERATION selector to select the desired mode (COOL
or HEAT).
EG
NOTE
The air conditioner will start in HIGH fan speed.
The temperature setting is 25°C for cooling mode and
21°C for heating mode.
2. WHEN THE AIR CONDITIONER IS RUNNING
If you want to turn off the air conditioner push the
OPERATION selector until the unit is in standby (red
operating lamp).
NOTE
Power failure during operation.
In the event of power failure, the unit will stop. When the
power is resumed, the unit will restart automatically after 3
minutes.

CARE AND CLEANING

WARNING
Maintenance operations must be carried out by specially
l
trained personnel.
For safety, be sure to turn the air conditioner off and also
l
to disconnect the power before cleaning.
Do not pour water on the indoor unit to clean it. This will
l
damage the internal components and cause an electric
shock hazard.
CASING AND GRILLE (INDOOR UNIT)
Clean the casing and grille of the indoor unit with a vacuum
cleaner brush, or wipe them with a clean, soft cloth.
If these parts are stained, use a clean cloth moistened with
a mild liquid detergent.
When cleaning the grille, be careful not to force the vanes
out of place.
CAUTION
Never use solvents, or harsh chemicals when cleaning the
l
indoor unit. Do not wipe the plastic casing using very hot
water.
Some metal edges and the vanes are sharp and may
l
cause injury if handled improperly; be especially careful
when you clean these parts.
The internal coil and other components of the outdoor
l
unit must be cleaned every year. Consult your dealer or
service centre.
20-07-2015 8:52
O P E R AT I O N
selector
10
Pagina 10

AIR FILTER

The filter behind the front panel should be checked and
cleaned at least once every three months or more frequently
in case of excessive dust in the room.
Do not use fire or air dryer to dry the filter, to avoid
deformation or fire hazard.
HOW TO REMOVE THE FILTER
Front panel
Air filter
1. Grasp both ends of the front panel and pull it towards you
and up.
2. Push the filter up slightly, and then pull it down. Clean the
air filter.
HOW TO REPLACE THE FILTER
Insert into the groove on the unit
1. With the «FRONT» mark facing you, slide the filter up
into the unit and insert it in its place.
2. After installing the filter, close the front panel.
FILTER CLEANING
Use a vacuum cleaner to remove light dust. If there is
sticky dust on the filter, wash the filter in lukewarm, soapy
water, rinse it in clean water, and dry it.