Advanced Settings For The Rf Prog Room Thermostat - Acova Z23020 Notice D'utilisation

RF_prog:RF_prog_ACOVA_7L 22/10/2010 09:19 Page42
4. Advanced settings for
the RF Prog room thermostat
Turn the dial to
rightmost button for 5 seconds until the
screen displays H200 x:xx (remote control
model number).
Press
4.1 Adjusting the room temperature
If the room temperature measured by the
thermostat deviates from actual room
EN temperature, the thermostat measurement
can be adjusted by up to +/- 4°C by pressing
the + and - buttons.
Press + or - to select the desired value then
press
menu.
4.2 Selecting the temperature
Using this function you can choose to
display either the room temperature
measured by your thermostat or the
setpoint temperature.
Press + or - to select the desired value then
press
menu.
42
NO HEAT
. The screen will display CF01.
OK
measurement (CF01)
to confirm and move to the next
OK
displayed in Auto mode (CF02)
to confirm and move to the next
OK
: room temperature always
displayed
1 : setpoint temperature always
displayed
and press the
5 sec.